Loading ...
Loading ...
Loading ...
OPTIONS DISH LOAD TYPES DESCRIPTIONS USE WITH:
Sanitize l
Tosanitize your dishes and
glassware in accordance
with NSF/ANSI Standard
184 for Residential
Dishwashers.
Raises the water temperature in the final rinse to
approximately 155°F (68°C). This high temperature rinse
sanitizes your dishes and glassware in accordance with
NSF/ANSI Standard 184 for Residential Dishwashers.
Certified residential dishwashers are not intended for
licensed food establishments.
The Sanitize or Sani Rinse option adds heat and time to the
cycle.
Normal Wash cycle.
Heavy Wash cycle
automatically uses
Sanitize. Only these
sanitization cycles have
been designed to meet
the NSF/ANSI
requirements.
For best drying results, drY Turn OFF When loads contain plastic dinnerware that may be All cYClesl Automatic
I Heated I dishes with heat: sensitivet° high temPe!atu!es! with al! wash cycles
Dry _ unless you turn It off
I I This option with the use of rinse aid will provide the best"
drying performance.
I 4 HourDelay I
To run your dish washer at Delays the start of a cycle up to 4 hours.
a later time or during off- Select a wash cycle and options. Press 4 HOUR DELAY.
peak hours. Press START/RESUME. Close the door firmly.
All cycles.
c0ntrol Lock To avoid Unintended use of To turn on Lock:, press and hold HEATED DRY forat least Anytime
your dishwasher, or cycle 4 seconds.
and opt on changes dur ng
Heated,-, I , ! " To turn off Locki press and hold HEATED DRY for at least
Dry _ a cyc e
I I ' 4 seconds,
when Control Lock is lit ai! buttons are disabled, if you press
any pad whi!e your dishwasher is locked, the light f ashes
3 timesl The dishwasher do0r can be 0pened wh le the
controls are locked.
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the
cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle
will automatically compensate by adding time, heat and water as needed.
CYCLE STATUS
CONTROL PURPOSE COMMENTS
I To start or resume a if the dOor is opened during a cYcle or the power is interrUpted, the StartJResUme indicatoi
Start/ / wash cycle flashes. The cycle will not resume until the START/RESUME button is pushed and the door is
Resume J cloSed Within 3 seconds.
To cancel wash Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
Cancel cycle drain completely.
=. To follow the The Clean indicator glows When a CYcle is finished.
m C°_i[°i_°ck progress 0f your If You select the Sanitize option; when the Sani Rinse Cycle is finished, the Sanitize indicator
alsnwasner CyCle
Clean glows. Ifyour dishwasher did not properly sanitize your dishes, the light flashes at the end of the
cyc!e, This can happen if the cycle is interruPted, or the water could not be heated to the required
temperature i The light goes off when you open and c!ose the door or press CANCEL
Loading ...
Loading ...
Loading ...