Loading ...
Loading ...
Loading ...
Freshautomatic
dishwasherdetergent
resultsinbetter
cleaning.Storetightly
closeddetergent
containerinacool,dry
place.
C
NOTE: For most water conditions, the
factory setting of 2 will give good
results. If you have hard water or notice
rings or spots, try a higher setting. Turn
the arrow adjuster inside the dispenser
by either using your fingers or inserting
a flat-blade screwdriver into the center
of the arrow and turning.
A. Cover latch
B. Main Wash section
C. Pre-Wash section
• The amount of detergent to use depends on:
How much soil remains on the items - Heavily soiled loads
require more detergent.
The hardness of the water - Ifyou use too little in hard water,
dishes won't be clean. If you use too much in soft water,
glassware will etch.
Soft to Medium Water (0-6 grains per U.S. gallon)
[typical water softener water and some city water]
Medium to Hard Water (7-12 grains per U.S. gallon)
[well water and some city water]
• Depending on your water hardness, fill the Main Wash section
of the dispenser as shown. Fill the Pre-Wash section to the
level shown, if needed.
NOTE: Fill amounts shown
are for standard powdered
detergent. Follow instructions
on the package when using
other dishwasher detergent.
HardWater
Soft Water
HardWater
SoftWater
MainWash Pre-Wash
Add Rinse Aid
Your dishwasher is designed to use rinse aid for good drying
performance. Without rinse aid your dishes and dishwasher
interior will have excessive moisture. The heat dry option will
not perform as well without rinse aid.
Rinse aid keeps water from forming droplets that can
dry as spots or streaks. They also improve drying by
allowing water to drain off of the dishes after the final
rinse.
• Rinse aid helps to reduce excess moisture on the
dish racks and interior of your dishwasher.
• Check the rinse aid indicator. Add rinse aid when indicator
drops to "Refill" level.
• To add rinse aid, turn the dispenser cap Lock
to "Refill" and lift off. Pour rinse aid into
the opening until the indicator level is at
"Full." Replace the dispenser cap and
turn to "Lock." Make sure cap is fully
locked.
Full
Add
Refill
turn to lock
Select a Cycle (cycles vary by model)
See "Cycle and Option Descriptions" charts inthe following
section.
Heavier cycles and options affect cycle length. Some cycles and
options will take up to 31/2hours to complete.
EVERYDAY CYCLES
ENTERTAINMENT CYCLES __
Select Options (options vary by model)
See "Cycle and Option Descriptions" charts in the following
section.
You can customize your cycles by pressing the options desired.
OPTIONS
STEP 4
Start or Resume a Cycle
• Run hot water at the sink nearest your
dishwasher until the water is hot. Turn off water. Start/
Resume
• Press START/RESUME and close the door
within 3 seconds. The door latches automatically. Press
START/RESUME to repeat the same cycle and options as in the
previous wash cycle.
• You can add an item anytime before the main wash starts.
Open the door slowly and add the item. Press START/RESUME
and close the door within 3 seconds.
Loading ...
Loading ...
Loading ...