Loading ...
Loading ...
Loading ...
Section 4: Opecation
Start engine according to instructions given in engine
owner's manuaH.AHso see operating instructions tag
Hocated on the pressure washer.
, WARNING
When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
Hfengine starts and fails to continue to run or if increased
resistance is felt during starting pull attempts, squeeze trigger
on spray gun.
NOTE; Always keep the throttle lever in the "Fast"
)osition when operating the pressure washer.
WARNING
DO NOT touch hot surfaces,
Allow equipment to coot before touching.
The pressure washer must be at least 5 feet from structures
having combustible walls and/or other combustible materials.
Keep at least 3 feet of clearance on all sides of pressure
washer for adequate coding, maintenance and servicing.
Hnthe State of California a spark arrester is required by law
(Section 4442 of the California Public Resources Code). Other
states may have similar laws. Federal laws apply on federal
lands. [f you equip the muffler with a spark arrester; it must be
maintained in effective working order:
How to Stoj Your Pressure Washer
H. Let engine idHe for two minutes.
2. Turn engine off according to instructions given in
engine owner's manual
3. Squeeze trigger on spray gun to relieve trapped
pressure in hose to avoid iniury.
NOTE: A smaHH amount of water wiHHsquirt out when
pressure is reHeased.
1
WARNING
Keep high pressure hose connected to pump and spray gun
while system is pressurized.
Squeeze trigger on spray gun to rdieve trapped pressure,
every time you stop engine. Engage trigger lock on spray gun.
4. Engage trigger Hock on spray gun when not in use.
The unit is equipped with an accessory tray with pHacesto
store your spray gun, nozzHe extension, turbo nozzle, and
ProjectPro TM nozzHes.There is aHsoa hook at the front of
the accessory tray to hoHd your high pressure hose.
NOTE:The extra hoHe in the tray is for storing a utility
brush.The brush is NOT incHuded with your pressure
washer.You can buy the brush as an optionaH accessory.
H. PHacenozzHe extension through hoHeon accessory tray,
as shown in Figure H2.
2. PHacespray gun through hoHeon accessory tray on
right side of unit (Figure H2).
NOTE:You may aHso use the hooks attached to the base
and handHe to store your gun and nozzHe extension, as
shown on page 5.
3. Push turbo nozzHe up and into chip on accessory tray
untiH it snaps in, as shown in Figure H2.
4. Hang high pressure hose on hook attached to accessory
tray on front of tray, as shown in Figure H2.
Loading ...
Loading ...
Loading ...