Loading ...
Loading ...
Loading ...
Hid-Level Lighting (some models)
The mid level and upper level lighting comes
on automatically when the door is opened.
To disconnect power to the unit, unplug
the unit or switch the breaker that supplies
power to the unit to the off position.
Replace the old bulb with a bulb of the
4. Replace LED
light and snap in
place assuring the
light is facing in
toward the unit
(inside fresh food).
LED Light Harness Removal
ii ii _
;; LED lights are in series, so if one is bad or
same wattage: unplugged, several lights may not light up.
To replace the light bulb:
1. Turn the temperature control to OFF and
unplug the electrical cord.
2. Remove the lens from the lamp housing
by unsnapping it from the lamp housing
using your fingers or a screwdriver. Be
careful not to break the locking tabs on
the lamp housing.
3. Replace the old bulb with a bulb of the
same type and wattage.
4. To replace the lens, snap one side of the
lens opening to the tab on the lamp housing.
Then carefully attach the other side.
To Remove Light Lens
PressTabs _._
In DirectionShown "qllL_l _,_
-
id Level Lighting
Upper-Level Lighting (somemodels)
The upper level lighting comes on
automatically when the door is opened.
To replace the light bulbs:
To disconnect power to the unit, unplug
the unit or switch the breaker that supplies
power to the unit to the off position.
Replace the old bulb with a bulb of the
same wattage.
1. To replace the light bulb, turn the
temperature control to OFF and unplug
the electrical cord.
2. Remove the light shield by pushing in on
the sides where the two tabs are located
in the back, and then rotate the light
shield down and out.
Mid=Level Lighting Light Bulb Removal
LED Lighting (somemodels)
To Replace LED Lights:
1. Unplug the
power cord.
2. Remove light cover by
pushing up and out.
3. Hold the LED cover
with one hand and
pull the connector
with the other hand
while pressing the
connector latch.
LED Light Removal
I_ Tabs _"-__Light Shield Tabs
3. Replace the old bulb with a bulb of the
same type and wattage.
4. When replacing the light shield, insert
the three tabs in the front of the light
shield into the slots in the control box and
then rotate the rear upward until the two
retaining latches lock into place.
Loading ...
Loading ...
Loading ...