Loading ...
Loading ...
Loading ...
W415-1349 / A / 03.18.15
46
EN
11.3 DOOR GLASS REPLACEMENT
Only available as an assembly complete with gasket. Glass not available separately.
A. Place the door frame down careful not to scratch the paint.
B. Bend up the glass retainers being careful not to snap them.
C. Remove the glass from the frame.
NOTE: Care must be taken when removing and disposing of any
broken glass or damaged components. Be sure
to vacuum up any broken glass from inside the
appliance before operation.
D. Center the gasketed glass inside the door
frame with the thick side of the gasket
facing up.
E. Bend the glass retainers located along the
edge of the door frame over the gasket
holding the glass in place making sure that the thick portion is
protruding past the retainer. Careful not to break the glass.
GLASS
RETAINERS
GLASS
GASKET
y
.
G
LA
SS
E
T
GLASS
GASKET
GLASS
RETAINER
A. Place the door frame face down careful not to
scratch the paint
!
WARNING
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
APPLIANCE BEFORE OPERATION.
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
REMOVED, CRACKED, BROKEN OR SCRATCHED.
11.4 CARE OF GLASS
5.1
DO NOT CLEAN GLASS WHEN HOT! DO NOT USE
ABRASIVE CLEANERS TO CLEAN GLASS.
Buff lightly with a clean dry soft cloth. Clean both sides
of the glass after the fi rst 10 hours of operation with a
recommended fi replace glass cleaner. Thereafter clean
as required. If the glass is not kept clean permanent
discoloration and / or blemishes may result.
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
!
WARNING
11.5 CARE OF PLATED PARTS
6.1
If the appliance is equipped with plated parts, you must clean fi ngerprints or other marks from the plated
surfaces before operating the appliance for the fi rst time. Use a glass cleaner or vinegar and towel to clean.
If not cleaned properly before operating for the fi rst time, the marks can cause permanent blemishes on
the plating. After the plating is cured, the fi ngerprints and oils will not affect the fi nish and little maintenance
is required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may cause
discolouration on plated parts.
NOTE: The protective wrap on plated parts is best removed when the assembly is at room
temperature but this can be improved if the assembly is warmed, using a hair dryer or similar heat
source.
5.5.1
This appliance is factory equipped with 5mm ceramic glass. Use only replacement glass available from your
Napoleon® dealer. DO NOT SUBSTITUTE MATERIALS.
Loading ...
Loading ...
Loading ...