Loading ...
Loading ...
Loading ...
° Follow cleaning instructions A-D.
• Remove the exhaust hose and window kit and repack the unit in its original
shipping box. Store unit upright in a dry place where the temperature will
remain above 35°t:.
• IMPORTANT: Always store and transport the unit so as to maintain the
compressor in a upright orientation.
MODEL 408.72012
VOLTAGE 120V-60Hz
AMPERAGE:
COOLING 12 Amps
HEATING 10.5 Amps
POWER CONSUMPTION:
COOLING 1400W
HEATING 1200W
COOLING CAPACITY 12r000BTU/h
HEATING CAPACITY 12r000BTU/h
DEHUMIDIFYING CAPACITY(30°Cr RH80%) 126.8 Pints/Day (60 Liters/Day)
NOISE LEVEL (Indoor use) 53 dB(A)
265 CFM maximum at high
AIR CIRCULATION (m3/h) fan speed
REFRIGERANT R410A
REMOTE CONTROL INCLUDED
TIMER 0-24h
21.7" x 12" x 29.9"/
DIMENSIONS (WxDxH) 55cm x 30cm x 76cm
NET WEIGHT 65 ibs/29.5 kcj
2O
If your air conditioner fails to operate_ please follow these procedures prior
to contacting customer service.
DO NOT ATTEMPT TO OPEN OR REPAIR THE AiR CONDITIONER
YOURSELF. DOING SO WiLL VOID THE WARRANTY AND CAUSE DAMAGE
OR PERSONAL iNJURY.
PROBLEM POSSIBLECAUSE SOLUTION
Can I turn the unit on immediately e No. The unit must be placed upright
after unpacking it? for at least 12 hours after every
transport. Otherwise the compressor
may be damaged.
Unit does not start when pressing • Lower the set temperature
power button
The air conditioner does not
come on
The air conditioner works for only
a short time
Room is not cod enough
The air conditioner does not
operate for about three minutes
after restarting it
o Room temperature is higher
than the set temperature
(heating mode).
o Room temperature is lower
than the set temperature
(cooling mode).
No electricity
o It is not plugged into the
outlet
• The internal safety device
has tripped
• The safety device on the
plug has tripped
• There are bends or Idnks in
the air exhaust hose
o Something is preventing the
air from being discharged
• Windows/doors in room
are open
• There are heat sources
nearby
t Exhaust hose is not
connected or is blocked
® Temperature setting is too
high
• Air filter blocked by dust
• The compressor control
prevents the unit from
being restarted until three
minutes have elapsed since
it was last turned off
® Raise the set temperature
e
o
o
Check house circuit breaker panel
for tripped switch.
Plug into outlet
Wait 30 minutes; if problem persists,
call 1-800-469-4663 to arrange for
product inspection and repair.
Reset the safety plug
o
e
Position the air hose correctly,
keeping it as short and free of
curves as possiuble to avoid
bottlenecks,
Check and remove any obstacles
obstructing air discharge.
Close all windows/doors
• Remove heat source if possible
® Connect the exhaust hose and make
sure it can function properly
e Decrease the set temperature
o Clean the air filter
Wait. This delay is part of normal
operation
Noise or vibrations • The floor is not level or the • Place the unit on a fla b level surface
unit is on an incline
Gurgling sound • The sound comes from • This is normal
the flowing of refrigerant
inside the air conditioner
21
Loading ...
Loading ...
Loading ...