Loading ...
Loading ...
Loading ...
7
Temperature Selection and Monitoring:
The temperature inside the freezer is controlled by a digital thermostat
located at the bottom of the unit at the right end of the front grille. The LED
display normally shows the temperature inside the freezer. If you find it
necessary to change the temperature setting (Set Point) of your appliance,
refer to the following instructions. The front panel of the thermostat is
illustrated here:
To see the Set Point:
Push and immediately release the SET key. The display will show the Set
Point value. Wait 5 seconds and the interior temperature value will display
again.
To change the Set Point:
Push and hold the SET key for more than 3 seconds to change the Set Point
value. The value of the set point will be displayed, and the “snowflake” LED
will start blinking.
To change the SET value:
Push the UP or DOWN arrow to the desired setting. The new setting will be
memorized after 15 seconds, provided no other keys are pushed.
NOTE: The minimum and maximum range of your thermostat is preset
and locked by us so it cannot easily be accidentally changed. To
reset this range lock, either call us or find information on our website
under Troubleshooting.
Defrosting:
The EQFM3D series are manual defrost all-freezers. No internal fans are
present, and ice will build up along the cooling coils. Periodically defrost the
ice (recommended when the ice level reaches a thickness of 1/4 to 1/2 inch).
NEVER USE A METAL INSTRUMENT as you can damage the cooling coils,
which will void your warranty and often cannot be repaired. To defrost,
disconnect from the power supply, empty the contents, remove the drawers
and provide a tray in the bottom to collect water. Use a hairdryer or other
source of warm air to melt the ice (or leave the power off for 24 to 48 hours).
melting
snowflake
UP & DOWN arrows
SET key
snowflake
Loading ...
Loading ...
Loading ...