Loading ...
Loading ...
Loading ...
REVIEW INSTALLATION
Take a few minutes to complete
this checklist. It will help assure you
that you have a proper installation
and increase your satisfaction with
your Kenmore ELITE TM dryer.
[] Check that all parts you removed
from the parts packages are now
installed.
[] Ensure that dryer is positioned in its
final location. Make sure vent is not
crushed or kinked.
[] Ensure that dryer is level by placing
a level on top of the dryer. Check side-
to-side first, then check front-to-back. If
dryer is not level, adjust the legs up or
down.
[] Check to make sure you have all
the tools you started with.
FINAL STEPS
[] Plug the power supply cord into
the grounded outlet or power supply.
[] Turn power supply on.
[] Wipe the interior of the drum
thoroughly with a damp cloth to
remove any dust.
[] Remove the blue protective film on the
console and any tape remaining on
dryer.
[] Read the rest of this manual to fully
understand your new dryer.
[] To remove air from the gas line, set the _
dryer on a full heat cycle (not the AIR
FLUFF setting) for 20 minutes. After _
five minutes, open dryer door. The _
burner should have ignited during _,_s
these five minutes. If you do not feel
heat, turn the dryer off and WAIT 5
MINUTES. During these 5 minutes
check to be sure dryer gas supply
valve is open. Repeat steps above. If
the burner still does not ignite, see
"TROUBLESHOOTING."
23
Loading ...
Loading ...
Loading ...