Loading ...
Loading ...
Loading ...
1. LOCATION
Place heater on the floor beneath the coldest window in the room, or any other location. Your heater will reduce the effect
of cold drafts.
The heater should not be placed immediately below a power outlet.
Do not use this radiator in rooms with a floor area of less than 43 square feet (4 sq. m.).
2. CONNECTION
The radiator should be connected to a properly polarized A/C 120 V household outlet in perfect working conditions.
Keep loose clothing or bedding, furniture and flammable material away from the heater’s wall outlet.
3. TURNING ON TWO-SWITCH MODELS
Turn the thermostat clockwise to its maximum position. Push down both switches. The switch lights stay on independently
of the thermostat cycling. When room reaches the desired temperature, turn the thermostat knob counter-clockwise very
slowly and carefully until you hear a click. This should set your heater to maintain the desired temperature by cycling on
and off as required. (For timer instructions, see paragraph 5.)
Note: The heater normally requires about 15 minutes to reach the desired temperature.
4. USE OF THERMOSTAT
The thermostat operates according to room air temperature, rather than radiator temperature. Turning it counter-clockwi-
se to smaller numbers would decrease the temperature; clockwise to greater numbers would increase the temperature.
Antifreeze function
Turn the thermostat dial to the position and push the switches on. The appliance will maintain a minimum room tempe-
rature of approximately 42°F (5°C), thus preventing freezing while conserving energy. In models that come with a timer,
tabs must be set in the inward position.
REMINDER
To completely shut the heater off, MIN/MED switches must be set in the “0” position.
5. UNITS WITH TIMER
Clock setting
The program/timer, as with all clocks, must be set to the correct time. If for example the time is 9.30 a.m. (day zone), rota-
te the dial clockwise (following the direction of the arrow) until 9.30 is aligned with the triangular pointer.
IMPORTANT:
DO NOT ROTATE CLOCK DIAL COUNTER-CLOCKWISE.
The timer is in effect an electric clock and would only work while it is plugged into a power supply.
When unplugged, the timer stops and must be later re-set.
4
With pilot lights ON, the heater is ON!
WATTS ECONOMIZER
For more economical use, the Min. or Med. Watt switches may be
used individually, after unit has reached the operating temperatu-
re.
Loading ...