Loading ...
Loading ...
Loading ...
To turn on the Lock
Press and hold
0
@
LOCKON
for 4 seconds. LOCK ON glows.
If you press any pad while your dishwasher is locked, the light
flashes 3 times.
To turn off the Lock
Press and hold AIR DRY for 4 seconds. The light turns off.
Delay Hours
Select this option to run your dishwasher at a later time or during
off-peak hours. You can add items to the load anytime during the
delay countdown. After adding items, close the door firmly until it
latches. The delay countdown will not continue if the door is not
latched.
• You can delay the start of a cycle up to 24 hours.
• The first time you use Delay Hours, you will see
showing a 1-hour delay.
To delay the start
1. Open the door.
2. Select a wash cycle and options.
3. Close the door.
4. Repeatedly press
QE_¥
HOIRS
until you see the desired hours of delay in the display.
When the delay reaches 24 hours, the delay turns off. Press
DELAY HOURS again to select a new number of delay hours.
5. Press START.
NOTE: To cancel the delay and cycle, press CANCEL/DRAIN. To
cancel the delay and start the cycle immediately, press START
again.
Follow the progress of your dishwasher with the Cycle Status
indicators.
_ llSl (I (>L[AI
Sensing
Your dishwasher senses the soil level on the dishes. Soil level
determines the length of some cycles, the amount of heat added
to the wash or rinse, and the cycle needed for the load. SENSING
glows during soil sensing, and while water is being heated. Wash
action continues while sensing occurs.
Sanitized
If you select the Sani Rinse option, SANITIZED glows when the
Sani Rinse cycle is finished.
If your dishwasher did not properly sanitize your dishes, the light
flashes at the end of the cycle. This can happen if the cycle is
interrupted. The light goes off when you press any button or
close the door.
Rinse Aid Empty
Fill the Rinse Aid dispenser when RINSE AID EMPTY is lit. Rinse
aids prevent water from forming droplets that can dry as spots or
streaks.
BIISEAIQ EMIIY
If the Rinse Aid dispenser is empty, the light glows when you
select a cycle or while a cycle is running.
The Active Vent reduces the sounds from your dishwasher. The
cover closes after the cycle starts. Filling and washing sounds are
reduced. The Active Vent opens when wash action ends and
vapor is vented into room.
NOTE: There is a slight noise when the cover closes or opens.
This is normal.
During drying, you can see steam escaping through the vent at
the upper left corner of the door. This is normal as the heat dries
your dishes.
IMPORTANT: The vapor is hot. Do not touch the vent
during drying.
The overfill protection float (in the front right corner of the
dishwasher tub) keeps the dishwasher from overfilling. It must be
in place for the dishwasher to operate.
Check under the float for objects that may keep the protector
from moving up or down.
Clean
CLEAN glows when a cycle is finished. The light turns off when
you press any button or close the door.
17
Loading ...
Loading ...
Loading ...