Loading ...
Loading ...
Loading ...
One 5/64” flat screw driver is needed for the Bypass Adjustment on Burner Valve .
a.
Please
take off the burner knobs to get access to the burner valve part. There's a hole located at bottom right of the burner valve,
providing access to the adjustment of burner valve bypass orifice. Take out the bezel if needed. The hole is part of the micro-switch (the
black part) sticking to the burner valve.
Use the screw driver to go across the micro-switch and reach the bypass orifice on the burner valve. Bypass orifice could help to control
the flame.
b.
Put
the knob back, adjust the flame by rotating the knob. The original location of bypass is for NG. If converted to LP, adjust the vertical
direction of the adjustment shaft groove is LP.If converted from LP to NG,adjust the horizontal direction of the shaft groove is NG.
Originally, the Bypass is located at NG Position and it's not screwed to the bottom (tightest)
For LP conversion of bypass, not bypass orifice needs to be changed. Screw the Bypass Orifice to bottom (clockwise).
c.
Save
the main bypass jets, in the plastic bag labeled main jets . When you are using your top burners, if the flame needs to be adjusted
accordingly to fit your need, please adjust the bypass orifices on the burner valve. Put back the knob on and adjust the flame by rotating
the bypass via a small flat screw driver. Check the flame's condition to get the best performance.
Adjust the horizontal direction of
the shaft groove is NG
The vertical direction of the
adjustment shaft groove is LP
1. Place the product on the desktop, and use
two cross-shaped flat-head screws to fix the desktop
fixing device on the product base.
2. The countertop pan-head screw passes
through the countertop fixing piece, and twist
the screw to lock the countertop.
INSTALLING THE COOKTOP
Loading ...
Loading ...
Loading ...