Loading ...
Loading ...
Loading ...
Adjusting the Oven Temperature
Your oven thermostat has been precisely set at the factory. This setting may differ from your previous oven,
however, so your recipe times may not give you the results you expect. If you think that the oven is cooking too
hot or cool for your recipe times, you can adjust the thermostat so that the oven cooks hotter or cooler than the
temperature displayed.
To Adjust Oven Temperature:
1. Press and hold for 6 seconds. The display now indicates the amount of degrees offset between the
original factory temperature setting and the current temperature setting. If the oven control has the original
factory calibration, the display will read _(00>}.
2. The temperature can now be adjusted up or down 35°F or 19°C, in I°F or 1°C steps by pushing and holding
the A or v until the desired amount of degree adjustment appears in the display. When lowering the oven
temperature, a minus sign (-) will appear before the number to indicate that the oven will be cooler by the
displayed amount of degrees.
3. When you have made the desired adjustment, wait 5 seconds for the adjustment to be accepted.
4. Press _ to cancel the adjustment.
Note: Oven temperature adjustment made will not change the Broil and the Self-Cleaning feature temperatures.
The temperature of both ovens can be adjusted individually.
Before You Call
Solutions to Common Problems
Before you coil for service, review this list. it may save you time and expense. The list includes common occurrences
that are not the result of defective workmanship or materials in this appliance.
OCCURRENCE
Oven Control Beeps and
Displays any F code error
(e×ample Fll).
d=O is dlsplayed.
Range not level. Poor
baking results.
Entire oven does not
operate.
POSSIBLE CAUSE/SOLUTION
Electronic control has detected a fault condition. Press STOP/CLEAR to clear the
display and stop beeping. Reprogram the oven. If a fault reoccurs, record the fault
number. Press STOP/CLEAR and call Sears or another qualified servicer.
The door was left open and controls set for self-cleaning cycle. Close the door.
Place oven rack in center of oven. Place a level on the oven rack. Contact installing agent if rack
and cabinet cutout flooring are not level.
Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets are square
and level. Contact cabinet maker to correct problem.
When the oven is first plugged in, or when the power supply to the oven has been
interrupted, the display will flash. The oven cannot be programmed until the clock
is set.
Be sure electrical cord is securely connected into the electrical junction box.
Cord/plug is not installed and/or connected. Cord is not supplied with oven.
Contact Sears or another qualified servicer.
Service wiring not complete. Contact Sears or another qualified servicer.
Power outage. Check house lights to be sure. Call your local electric company.
Short in cord/plug. Replace cord/plug.
Controls are not set properly. See instructions under Setting Oven Controls to set
the controls.
House fuse has blown or circuit breaker has tripped immediately following
installation. House fuse may not be fully engaged. Check fuse and screw or
engage circuit breaker securely.
House fuse has blown or circuit breaker has tripped after the oven has been
installed and previously operating. Call Sears or another qualified servicer.
21
Loading ...
Loading ...
Loading ...