Loading ...
Loading ...
Loading ...
801912 - G4 BCS, BCSHA Commercial User Guide - July 2015 - v2.00 Page 15 of 28
After replacing the filter, the counters should be reset
2. - Filter Reset
LCD Screen operation - Section C
1.
Press the [MENU] button for main
menu.
2.
Press the [Install] button.
3.
Press the [Filter Reset] button.
4.
To set the filter life or edit filter
usage, refer to section G- Filter.
On start up, the Zip HydroTap starts a self-calibration program. The controls
take the system through the calibration process. Once complete, the system
reverts back to normal operation. If you would like to calibrate the system
anytime after initial installation, please follow the steps below.
1. Press [MENU] button for main
menu.
2. Press [Install] button.
3. Press [Boiling Calibration] button.
4. In the next screen, press [Calibrate]
to start calibration.
3 - Boiling Calibration
Caution:
During calibration, boiling water units may vent steam from the
tap spout. Take care to avoid personal injury whenever this occurs.
This function should only be considered when a Booster unit is installed.
4 - Booster
Note:
Failing to make the correct selection for ‘Booster’ will effect product
performance.
1.
Press the [MENU] button for main
menu.
2.
Press the [Install] button.
3.
Press the [Booster] button.
4.
If a Booster is installed, select
YES to enable the Booster.
5.
Dispense boiling water for a
minimum of 30 secs and check
the outlet hose from the Booster
is warm.
6.
If no Booster is installed select
NO,
Loading ...
Loading ...
Loading ...