Loading ...
Loading ...
Loading ...
33
Status Monitor
When the projector is in a normal condition,
or displays one of the warnings of AIR FLOW,
COLD or FILTER errors, press the FUNCTION
button on the control panel, press the ENTER
button on the remote control for three seconds
or press one of the MY BUTTON buttons if
assigned as STATUS MONITOR. The backlight
of the monitor turns on.
To display the setup information including
usage time
Use the ◄/► buttons to switch display.
Usage time: The Status Monitor displays
the lamp time (usage time of the present
lamp), the lter time (usage time of the air
lter) and the projector usage time.
Network information: The network information is displayed over three pages.
Use the ▲/▼ buttons to switch the page.
Displayed information in each page is as below;
2nd page
: Subnet mask
(wireless and wired)
1st page
: IP address
(wireless and wired)
3rd page
: Default gateway
(wireless and wired)
(continued on next page)
2
N 1 9 2 1 6 8 0 0 1 0 7 5
W
1 9 2 1 6 8 0 0 1 9 6
I P A D D R E S S
S Y S T E M 2 2 3 8 6 h
F I L T E R 1 2 8 3 5 h
0 L A M P 2 2 5 0 h
Displaying the log
The present setup information and the error history can be displayed on the
Status Monitor with button operation.
• While the projector is warming up, button presses are ignored.
• The Status Monitor displays nothing or no button presses for the monitor are
available while the projector is in standby mode if the STANDBY MODE item of
SETUP menu is set to SAVING (78).
• Both of the Status Monitor and the OSD menu cannot be operated at the
same time.
NOTE
FUNCTION
button
ENTER
button
Usage time (example)
Network information
(example)
First display Usage time
Network
information
Lamp time
Filter time
Projector
usage time
Wired
Wireless
Loading ...
Loading ...
Loading ...