Loading ...
Loading ...
Loading ...
26
Programming
Your hand-held remote control (model 893MAX) has already programmed to the door control (myQ Control Panel) at the factory. Below
are instructions for programming additional remote controls, keyless entries, and myQ enabled accessories to the door control.
NOTE: Use the learn button on the door control to program all accessories. The yellow learn button on the garage door opener will NOT
program accessories.
PIN
?
?
??
REMOTE CONTROL
1. Press the myQ Control Panel LEARN button twice,
the red learn LED will turn on.
2. Press the button on the remote control that you
wish to operate your garage door.
3. The garage door opener lights will flash (or two
clicks will be heard) when the code has been
programmed.
1. Press the myQ Control Panel LEARN button twice, the
red learn LED will turn on.
2. Enter a 4-digit personal identification number (PIN) of
your choice on the keyless entry keypad. Then press
the ENTER button.
3. The garage door opener lights will flash (or two clicks
will be heard) when the code has been programmed.
KEYLESS ENTRY
LEARN
Button
LEARN
Button
Model 825LM - Remote Light Control
Light module can be synchronized with
the garage door opener light bulbs.
Model 823LM - Remote Light Switch
Light module can be synchronized with
the garage door opener light bulbs.
LEARN
Button
Model 829LM - Garage Door and Gate
Monitor
Indicates the status of your garage door
from inside the home and allows you to
close an open garage door from inside the
house.
myQ ENABLED ACCESSORIES
1. Press the myQ Control Panel
LEARN button twice, the red learn
LED will turn on.
2. Press the LEARN button on the
myQ device.*
* myQ accessories may be programmed
to the LiftMaster
®
Internet Gateway
(Model 828LM) or the myQ control
panel. For instructions on
programming to the LiftMaster
®
Internet Gateway refer to the manual.
Command
LED (yellow)
Learn LED
(Red)
To Add a Remote Control, Keyless Entry, or myQ Enabled Accessories using the
Door Control (myQ Control Panel)
Loading ...
Loading ...
Loading ...