Loading ...
Loading ...
Loading ...
m
1. Rest the back cavity of the hood on the wood mounting
strip.
_1 CAUTION: Hold the hood until it is completely
secured to the wood mounting strip.
Secure hood to wood strip with (4) screws #8 - 3A"provided
at location shown. Drill (2) 3h6" size holes into the drywall
for wall anchors through the existing holes in the inside
hood back in the locations shown. Then install the (2) _]L1
anchors and attach the hood to these anchors with the
remaining #8 - H" screws and the (2) washers provided.
m
m
HD0171
m
m
2. Attach transition (if required) to blower rough-in plate.
Refer to page 5 for available model numbers.
Use duct tape to make all joints secure and air-tight
Model 32685 blower plate connects directly to 7" round duct
without a transition.
Exterior blower model 32675 utilizes a model 32674
mounting plate which connects directly to 10" round ductwork
without a transition.
@
_b
m
m
3. Run power cable to installation location. Refer to the
instructions included with the selected blower / rough-in
kit (sold separately) for details on installing the rough-in
plate. Install the rough-in plate so that the wiring box is
located on the right side as you are facing the hood.
For ducting through back of hood, remove existing plate
from inside back of hood and attach to inside top of hood
to cover hole. Secure to threaded studs with same (4)
nuts.
For ducting through top of hood, existing plate remains in
place on inside back of hood.
Connect ducting to transition or rough-in plate as you are
installing the rough-in plate. Use duct tape to make all
joints secure and air-tight
HO0086
HO0087
2
9 m
Loading ...
Loading ...
Loading ...