Loading ...
Loading ...
Loading ...
INSTALLATION
INSTRUCTIONS
s Re 5ss s
Are you placing the dryer on a pedestal? You can purchase a
pedestal separately for this dryer. This pedestal will add about
14 in. (35.56 em) to the height of your unit for a total height of
approximately 52 in. (132.08 era).
Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
• 8in. or 10 in. pipe wrench • Knife
• 8 in. or 10 in. adjustable • Safety glasses
wrench (for gas
connections) • Duct tape
• Flat-blade screwdriver • Pipe-joint compound
resistant to L.R gas
• Adjustable wrench that
opens to 1 in. (2.54 cm) • Caulking gun and
or hex-head socket compound (for installing
wrench (for adjusting new exhaust vent)
dryer feet) • Gloves
• Level • Pliers
• Y4in. nut driver or socket
wrench
Parts supplied
Remove parts package from dryer drum. Check that all parts
were included.
4 Levelinglegs
NOTE: Do not use leveling legs if installing the dryer on a
pedestal.
Parts needed
Check local codes and with gas supplier. Check existing gas
supply, electrical supply and venting. Read "Electrical
Requirements," "Gas Supply Requirements" and "Venting
Requirements" before purchasing parts.
• For close-clearance installations between 31.5 in. (80.01 cm)
and 37 in. (93.98 cm), see "Plan Vent System" section for
venting requirements.
I< 87,, >1
(93.98 ¢m)
Mobile home installations require special parts (listed following)
available for purchase from your local Sears store or Sears
Service Center. For further information, please call
1-800-4-MY-HOME _ (1-800-469-4663).
• Mobile Home Installation Kit. Ask for Part Number 346764.
• Metalexhaust system hardware.
Optional pedestal
The pedestal is available in three colors
White - Part Number 42842
Biscuit - Part Number 42844
Graphite - Part Number 42846
To order, call your local Sears store. For further information,
please call 1-800-4-MY-HOME _ (1-800-469-4663).
Lee@:on
u el
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the
floor for a garage installation.
Failure to do so can result in death, explosion,
or fire.
You will need
• A location that allows for proper exhaust installation. A gas
dryer must be exhausted to the outdoors. See "Venting
Requirements."
• A grounded electrical outlet located within 2 ft (61 cm) of
either side of the dryer. See "Electrical Requirements."
• A sturdy floor to support the total dryer weight of 200 Ibs
(90.7 kg). The combined weight of a companion appliance
should also be considered.
A level floor with a maximum slope of 1 in. (2.5 cm) under
entire dryer. (If slope is greater than 1 in. [2.5 cm], install
Extended Dryer Feet Kit, Part No. 279816.) Clothes may not
tumble properly and automatic sensor cycles may not
operate correctly if dryer is not level.
• For a garage installation, you will need to place the dryer at
least 18 in. (46 cm) above the floor. If using a pedestal, you
will need an additional 6 in. (15.24 cm).
Loading ...
Loading ...
Loading ...