Loading ...
Loading ...
Loading ...
76 - CLEANING AND MAINTENANCE 914779946/B
Setting of a programmed Pyrolytic cycle
It is possible to program the Pyrolytic cycle start
time like all other cooking functions.
1. After selecting the Pyrolysis function, turn the
temperature knob (the indicator light
lights up) to set the time at which you want
the Pyrolysis function to end.
2. Wait 3 seconds to confirm the data entered.
The appliance waits until the set start time to start
the Pyrolytic function.
End of pyrolytic function
1. Turn the function knob to position 0 to exit
the function.
2. Open the door and collect the residue
deposited inside the oven cavity with a
damp microfibre cloth.
Cleaning the water circuit
Periodically the appliance will display that the
descaling procedure of the hydraulic circuit is
required.
Preliminary operations
1. Open the door
2. Place the deep pan on the third shelf from
the bottom. Push it against the rear wall of
the oven cavity.
3. After entering the special functions menu,
turn the temperature knob until the Descaling
function is selected.
4. Press the temperature knob to confirm.
The display shows a request to drain the
reservoir
.
5. Press the temperature knob again to start the
function.
The water (or detergent) starts to flow into the
deep pan from the drain pipe on the right side
of the rear wall of the oven cavity.
During the Pyrolytic cycle the fans
produce a more intense level of noise
due to a greater rotation speed. This is
an absolutely normal operation,
intended to provide more effective heat
dispersal. At the end of the pyrolytic
cycle, the fans will continue to operate
for long enough to avoid overheating
the walls of adjacent units and the front
of the oven.
During the first Pyrolytic cycle,
unpleasant odours may occur due to
the normal evaporation of oily
manufacturing substances. This is an
absolutely normal phenomenon which
disappears after the first pyrolytic cycle.
If the pyrolytic cycle gives unsatisfactory
results at minimum duration, it is
recommended to set a longer time for
subsequent cleaning cycles.
It is not possible to select any function
once the door lock device has been
activated. It is always possible to switch
the appliance off, by turning the function
knob to the 0 position.
We recommend wearing rubber gloves
for these operations.
For easier manual cleaning of parts that
are difficult to reach, we recommend
removing the door.
The presence of scale due to lack of
descaling can compromise correct
operation of the appliance in the long
term.
Loading ...
Loading ...
Loading ...