Loading ...
Loading ...
Loading ...
TO REPLACE BELT
1. Slide washers
and end caps onto
agitator assembly.
2. Install new
belt over motor
drive, then
over brush
sprocket.
NOTE; Use
belt #20-5201.
In Canada,
#20-40979.
3. Place agitator
assembly back into
Power-Mate ®.
4. Reinstall
agitator
cover by lin-
ing up the
front tabs
and slots
and rotating
downward
until the
latches
Agitator Cover
snap into place.
5. Line up
front of
\
cover and
base. Rest
cover on __
front edge of
base as
shown,
Cover
Base
\
6. NOTE: On
dirt sensor mod= )
els be sure that
the board is
upright and the
wires are tucked
back as shown, k4
[ Top View
7. Rotate cover
back, Press cover
firmly until side
and rear tabs snap
into place. Turn
Power-Mate ®
upside down and
replace two (2)
cover screws_
1. Remove Power-Mate ® cover as shown in
BELT CHANGING AND AGITATOR CLEAN-
ING section.
Push in
And Turn
2. Push in and turn
bulb counterclock-
wise, then pull out
to remove,
Push In
And Turn
3. Push in and turn
bulb clockwise, to
replacer Bulb must
not be higher than
15 Watts(130 Volts).
18
4. Reinstall Power-Mate e cover as shown in
BELT CHANGING AND AGITATOR CLEAN-
ING section.
NOTE: Use bulb #20-5240. In Canada,
#596181o
Loading ...
Loading ...
Loading ...