Loading ...
Loading ...
Loading ...
r4 Storing the Clothes Washer. ............................. .
Washers can be damaged if water is not removed from
hoses and internal components before storage. Prepare
the washer for storage as follows:
• Select the "NORMAL" setting on the REGULAR
cycle of the clothes washer and add or_e cup of bleach
to the detergent dispenser without clothes in the tum-
bler. Run the clothes washer through a complete
cycle.
Turn the water faucets off and disconnect the inlet
hoses.
Advance the cycle control knob to Spin and lower
the drain hose to eliminate any water that may be in
the drain hose,
Disconnect the clothes washer from the electrical
supply and leave the washer door open to let air cir-
culate inside the tumbler.
For information on long.term storage or storage of your washer during extreme cold temperatures, call Maytag
Customer Service toll-free at 1-888-462-9824.
U.S. customers using TTY for dear, hearing impaired or speech impaired, call 1-800-688-2080.
F-\
Replacing Interior Light .....................................
Instructions for replacing the bulb:
1) Unplug or disconnect the clothes washer from the electrical power supply.
2) Open the door and use a Phillips screwdriver to remove the screw attaching the light
cover to the door lock assembly.
3) Pull down on the light cover.
4) Unscrew the light bulb counter clockwise from the socket.
5) Replace the bulb with a 10 watt candelabra base light bulb and rotate clockwise.
6) Replace the light cover by inserting the front tabs into the door lock assembly. Push
the rear of the light cover into position.
7) Replace the screw into the light cover/door lock assembly.
8) Plug in or reconnect clothes washer to the power supply.
Reversing the Clothes Washer Door.... ..............
Clothes washer door swing direction can be changed using the following procedure:
1) Swing door fully open and support it while removing tkmr hinge screws (which hold hinges to door assembly).
2) Set door aside and transfer four color matched door screws to the opposite side of the door assembly.
3) Remove one screw holding top hinge to cabinet and one screw holding top hinge cover to cabinet (opposite side).
4) Remove hinge and bracket from cabinet by moving them up and down to a position where they are released.
5) Install hinge and bracket in swapped locations and drive screws to attach them securely to the cabinet.
6) Compare top hinge and top bracket to bottom hinge and bottom bracket for correct assembly position.
7) Repeat procedures 4 through 6 for bottom hinge to / _ co_o_so_kso_ow,=g
cabinet and bottom bracket to cabinet. :::::::::-::::;_:::::::::::::::
8) Support door in fully open position on hinge f_i ,':::;:::---::_:::"'_'''
side and drive four screws to securely attach i "':::i _
hinges to door assembly, i !! iii
9) Close door and check to see that clothes wash
cr operates properly.
:............ :::::::......... to'
/
9
Loading ...
Loading ...
Loading ...