Frigidaire CWS3600AS0 washer

User Manual - Page 10

For CWS3600AS0.

PDF File Manual, 13 pages, Download pdf file

Loading ...
Loading ...
Loading ...
OCCURRENCE
WATER
POSSIBLE CAUSE SOLUTION
Wash load too wet after Washer isoverloaded. Donotoverloadwasher.SeeWashing Procedures.
spin.
Load isout of balance. Rearrangeload to allow proper spinning.
Drain hose iskinked. Straighten drain hose.
Water does not enter Water supply isnot adequate in area. Checkanotherfaucetinthehouse. Waituntilwater
washer or it enters slowly, supply and pressure increase.
Water supply faucetsare not completely open. Fully open hot and cold faucets.
Water is being usedelsewhere in the house. Water pressure must be at least 30 psi(260 kPa).
Avoid running water elsewhere while washer is
filling.
Water inlet hoses are kinked.
Straighten hoses.
Water level doesnot cover Improper water levelselection(for modelswith
load. water level/load sizecontrol).
Select higher water level/load size.
Washer is overloaded. Do not overload washer. When control is set at
highest fill level, dry load level should not be higher
than top row of circular holes in wash tub.
Warm or hot water isnot
hot enough.
Hot water heater issettoo low or isa distance
from washer.
Measure hot water temperature at nearby faucet
with candy or meat thermometer. Water
temperature should be at least 130°F (70°C). Adjust
water heater as necessary.
Hot water isbeing used elsewhere in the house. Avoid using hot water elsewhere before or during
washer use. There may not be enough hot water
available for proper cleaning. If problem persists,
your hot water system may be unable to support
more than 1 use at a time.
Water in washer does not Drain hose iskinked or clogged.
drain or drains slowly.
Clean and straighten the drain hose.
Water leaks. Fill hose connection at faucet or washer.
Check and tighten hose connections. Install rubber
sealing washers provided.
House drain pipes are clogged. Unclog drain pipes. Contact plumber if necessary.
Oversudsing. Use less detergent.
Incorrect wash and rinse Hot and cold water hoses are connected to Connect hot water hose to hot water faucet and
temperatures, wrong supply faucets, cold water hose to cold water faucet.
Water is entering washer Drain hose standpipe is incorrect height. Standpipe must be a minimum of 33" (83.82 cm)
but tub does not fill. high to prevent siphoning. See INSTALLATION
INSTRUCTIONS.
11
Loading ...
Loading ...
Loading ...