Loading ...
Loading ...
Loading ...
English - 15
Connecting the drain hose
The end of the drain hose can be positioned in three ways:
In a Wall standpipe or Floor standpipe
The height of end of standpipe must be no lower than 39 in (99 cm) and no
higher than 96 in (245 cm).
If drain pipe are built into the wall with water valves (A), fasten the drain hose
to the water hose.
Make sure that the connection between the drain hose and the
standpipe is not airtight.
In a laundry tub
The height of the tub must be no lower than 39 in (99 cm) and no higher than
96 in (245 cm).
Assemble the supplied Hose guide at the end of the drain hose, and put the
hanger on laundry tub.
And fasten the drain hose to the leg of laundry tub.
Connect the hose guide (A) within 3~5 in (7.6~12.7 cm)* from the end of
the drain hose. If the drain hose is extended beyond the end of the hose
guide, mold or microorganisms could spread inside the washer.
Drain Hose can be installed until 96 in (245cm) maximum. But drain
capability can be reduced at this height. It causes the washer to have
odor, because of remained water in the drain system.
If the drain hose is installed below 39 in (99 cm), water can be drained in cycles due to a
siphon phenomenon. It causes the washer to display a “4E” error code.
STEP 3
Leveling your washer
See if the washer is level by checking the position of the tub:
1. Slide the washer into position.
2. Open the lid of the washer, and pour the water into the tub to
just below the pulsator level.
3. If the washer is level, the pulsator is positioned at the center of the
water as shown in the figure. If not, level your washer by turning the
front leveling feet clockwise or counterclockwise as necessary.
Turn the front leveling feet clockwise to raise the washer, and
counterclockwise to lower the washer.
A
*
A
01 installing your washer
Loosen Lock
Pulsator
Adjustable legs
(three)
WA7000HA WASH_WA48H_USER MANUAL_DC68-03133P-13_EN.indd 152016/6/22 10:33:23
Loading ...
Loading ...
Loading ...