Loading ...
Loading ...
Loading ...
15
newair.com
OPERATING INSTRUCTIONS
• Use the fan under the voltage and frequency shown on the rating label, do
not use in corrosive environment.
• Do not install this appliance in places where the altitude is higher than
3,280 ft or temperature is over 104 F.
• When socket is used in power supply, the socket should meet the IEC335-1
standard; when power liner is from direct power supply, a polarity switch
should be installed with contact gap no less than 1/8 inch on the fixation
wiring.
• Oscillating angle adjustment: loosen the oscillation screw and move it to
the desired position (the more outward the bigger oscillation angle),
tighten oscillation screw after adjustment to maintain the desired
oscillation motion.
• Tilting angle adjustment: loosen the fixing nut and move the motor to the
desired position, tighten the fixing nut to secure the angle.
• Speed adjustment: low speed, medium speed and high speed can be
achieved by turning the switch knob on the motor to the specific speed
needed.
• If appliance is selected to operate on misting mode, its misting magnitude
can be adjusted gradually by turning between "off" and "on".
• The tank must be filled to max level with water to use the misting mode.
The fan can operate continually for 4 hours with the maximum misting
setting. Re-fill the tank whenever needed to keep using misting option. To
unload water after using or cleaning the tank, unscrew the knob on the
bottom.
• When using the handcart, please lock the front cartwheel to avoid slipping.
To move the handcart, loosen the front cartwheel lock.
• Clean the water tank before using and take out the water pump before
cleaning the water tank.
Loading ...
Loading ...
Loading ...