Loading ...
Loading ...
Loading ...
6
INSTALLATION INSTRUCTIONS
Before Using your Appliance
Remove the exterior and interior packing.
CAUTION: After unpacking you MUST allow your appliance to stand upright for at least 2 hours to
allow the lubricant and refrigerant to drain back into the compressor and stabilize. Failure
to do so may adversely affect performance and the lifetime of the unit.
Clean the interior surface with lukewarm water using a soft cloth.
Install the handle on the door. (See page 8.)
Installation of your Appliance
The appliances are designed for either built-in or free-standing installation. DO NOT store or
install the appliance outdoors.
CAUTION: This appliance is designed for storing and cooling beverages and drinks. Do not store
perishable food, medicine or other medical products.
Place your Beverage Merchandiser on a floor that is strong enough to support it when it is fully
loaded. To level the unit, adjust the front leveling legs.
For freestanding installation, 5 inches (127 mm) of space between the back and sides of the unit
are suggested, which allows the proper air circulation to cool the compressor and condenser for
energy saving. Even for built-in installation, it is a must to keep 2 to 3 mm of space (about 1/10")
on each side and at the top, and 2 inches (51 mm) at the back, to ensure proper service access
and ventilation. And the air vent at the front of the appliance must never be covered or blocked in
any way.
NOTE: It is recommended that you do not install the appliance near an oven, radiator or other
heating source. Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Don’t install in a location where the temperature will fall below 60°F
(16°C). For best performance, do not install the appliance behind a cabinet door or block the
base grille.
Avoid locating the unit in moist areas.
Plug the Beverage Merchandiser into an exclusive, properly grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center.
Loading ...
Loading ...
Loading ...