Loading ...
Loading ...
Loading ...
Locking/Release
Button in Primary Hole
For assembly of optional attachments
(see list on page 13), refer to the
ASSEMBLY section of the applicable
attachment operator's manual.
ASSEMBLY INFORMATION -
LINE TRIMMER ATTACHMENT
%t TRIMMER
HEAD
GearboxJ__
Dust cup _ \
_ Aligned holes
Retaining
4
washer _,
Trimmer head L_--_J_i,_
4. Remove the screwdriver.
ATTACHING THE PLASTIC SHIELD
_IkWARNING: The shield must be
properly installed. The shield provides
partial protection from the risk of
thrown objects to the operator and
others and is equipped with a line lim-
iter blade which cuts excess line to the
proper length. The line limiter blade
(on underside of shield) is sharp and
can cut you.
1. Remove wing nut from shield.
2. Insert bracket into slot on shield.
3. Pivot shield until bolt )asses
through hole in bracket.
INSTALLATION OF THE TRIMMER
HEAD
NOTE: Before installing the trimmer
head, make sure the dust cup and re-
taining washer are positioned on the
shaft of the gearbox. The retaining
washer must be positioned with the
raised section toward the gearbox.
1. Align hole in the dust cup with the
hole in the side of the gearbox by
rotating the dust cup.
2. Insert a small screwdriver into
aligned holes. This will keep the
shaft from turning while tightening
trimmer head.
NOTE: Make sure all parts are prop-
erly installed as shown in the illustra-
tion before installing the trimmer head.
3. While holding the screwdriver in
position, thread trimmer head onto
the shaft by turning counterclock-
wise (looking from bottom of unit).
Only tighten hand tight!
4,
Shield
Slot
Reinstall wing nut and tighten se-
curely.
Loading ...
Loading ...
Loading ...