Loading ...
Loading ...
Loading ...
FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the floor. This surface
should be strong enough to support a fully loaded
refrigerator, or approximately 3351bs (152kg).
To protect the finish of the flooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working. When
moving the refrigerator, you need to pull and push
it straight forwards or back. Do not wiggle it from
side to side.
ACCESSORIES AND
REQUIRED TOOLS
The following accessories are included with your
refrigerator:
Hex wrench Fastener
Required Tools (Not provided)
You need the following tools to complete the
installation of your refrigerator:
Philips Flat-blade screw Socket wrench
screwdriver(+) driver(-) (10turn)
Allen wrench
Pliers
(3/16") (5rnrn)
REMOVING THE
REFRIGERATOR DOORS
For some installations you need to remove the
fridge and freezer drawers so you can move the
refrigerator to its final location. Do not remove
the doors/drawer if you don't need to. If you do
not need to remove the refrigerator doors, go
to Adjusting the Level on page 9. If you need to
remove the doors, continue below.
Before removing the door/drawer, make sure you
read the following items:
Z_ Disconnect power to the refrigerator before
WARNINGremoving the door or drawer.
• Be careful not to drop, damage or scratch
the door/drawer while removing them.
Use care when you remove the doors/drawer. The
doors are hea W and you could injure yourself.
Reattach the doors/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
-Wasting energy due to improper door seal.
HOW TO ASSEMBLETHE HANDLE
Orient each handle so that the end with the sticker
attached is at the top and the holes with the
tightening screws are facing each other.
Then, follow the directions below to install each
handle.
By using Phillips screwdriver, fix the screw
(optional) and then put the handle on the fixer
by sliding them down firmly.
settir_g up 07
Loading ...
Loading ...
Loading ...