Loading ...
Loading ...
Loading ...
21
INSERT PELLET STOVE INSTALLATION
U.S. Stove Pellet Burning Room Heaters are also available as an insert into existing masonry of factory-built replaces. Do
not alter the existing replace in any way either by removing bricks and mortar which could weaken the structural integrity of
the replace. There is a small amount of assembly required when installing this model. The steps are as follows:
Note: The shroud must be installed before unit is set into its nal position.
Step 1: Shroud Side: Facing the back of the unit take the left shroud side piece (no control panel hole) and fasten, as shown,
with 2 screws provided.
Step 2: Shroud Side: Facing the back of the unit take the right shroud side piece (with control panel hole) and
fasten, as shown, with 2 screws provided.
Figure 16
Screw Here
Screw Here
Figure 17
Screw Here
Screw Here
Loading ...
Loading ...
Loading ...