Loading ...
Loading ...
Loading ...
xi
Important Safety Instructions
1.
Read these instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
Do not use this apparatus near water.
6.
Clean only with a dry cloth.
7.
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8.
Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including
amplifiers) that produce heat.
9.
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and
the point where they exit from the apparatus.
10.
WARNING: Please refer the information on exterior bottom enclosure for electrical and safety information
before installing or operating the apparatus.
11.
WARNING: The main plug is used to disconnect the device and should remain readily operable.
12.
When not in use, tie up the power cordset with a cable tie or with something similar. It should not be near
sharp edges as it may cause abrasion of the power cordset. When put into use again, please make sure the
power cordset is not damaged. If any damage is found, please use a replacement power cord specified by
the manufacturer or that is identical to the original one.
13.
No open flame sources, such as lit candles, should be placed on, under, or near the apparatus.
14.
Unplug this apparatus during lightning storms or when unused for long periods of time.
15.
Only use attachments/accessories specified by the manufacturer.
16.
Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid
any injury.
17.
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have
fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or
has been dropped.
18.
For safe operation of the apparatus, please follow these installation requirements:
Keep at least 2 inches of ventilation space between the rear cover of the apparatus and the wall. Keep at
least 1 inch of ventilation space between the apparatus and all other surfaces. Do not allow any of the
apparatus’ ventilation openings to be blocked by objects that might obstruct them, such as newspapers,
curtains, table-cloths or any other objects. Do not expose the apparatus to any external heat sources. Do not
place any heat sources such as candles, lamps, etc. on the apparatus. Do not expose the device to high levels
of humidity or to any possible sources of moisture. When disposing of used batteries from the remote
control, consult local regulations regarding proper disposal.
19.
If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is
grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of
the National Electrical Code, ANSI/NFPA No. 70-2011 (Section 54 of Canadian Electrical Code, Part 1)
provides information with respect to proper grounding of the mast and supporting structure, grounding of
the lead in wire to an antenna-discharge unit, size of grounding conductors, location of antenna discharge
unit, connection to grounding electrodes, and requirements for the grounding electrode.
See following example:
Loading ...
Loading ...
Loading ...