Loading ...
Loading ...
Loading ...
10- ENG
4
Connect Spray
Wand to Spray
Gun
Thread the spray wand into
the end of the spray gun.
5
Connect QC
Nozzles to Spray
Wand
Pull quick connect cou-
pler back and insert
nozzle. Release quick
connect coupler and
twist nozzle to make sure
it is secure in coupler.
6
Turn Water
Faucet
Completely On
Do not run the unit
without water supply
connected and turned on.
Use Cold Water Only.
7
Release Air from
System
Release all air from
pump and high pressure
hose by depressing
trigger until a steady
stream of water is present.
Approximately 30 seconds.
8
Verify the Fuel
Valve is turned to
the OPEN
Position
The Fuel Valve has been
preset by the factory to
be in the OPEN position.
See Label #8 on the
side of the engine.
OFF
ON
9
Verify the Engine
Switch is turned
to the ON
Position
See Label #9 on the
side of the engine.
OFF
ON
10
Verify the Choke
Pin is Pulled Out
to the CLOSED
Position
The Choke Pin has been
preset by the factory to be
in the CLOSED Position.
See Label #10 on the
side of the engine.
11
Pull the Recoil
Starter Grip
Pull the
recoil starter grip to
start the engine.
See Label #11 on the
side of the engine.
12
Push the Choke
Pin to the OPEN
Position
Gradually move the Choke
Pin to the OPEN Position
after engine starts.
See Label #12 on the
side of the engine.
WARNING: This Guide is not a substitute for reading the operator's manual. User must
read and understand operator's manual before using this product.
Loading ...
Loading ...
Loading ...