Loading ...
Loading ...
Loading ...
page 4
5. Fan Assembly.
set screw
hanging ball
stop pin
diagram 2
diagram 1
diagram 3
canopy
motor
housing
yoke cover
canopy
cover
downrod
downrod
electrical wiring
safety cable
yoke set
screw
and nut
clip
pin
anti-sway
adapter
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower hanging
ball and remove stop pin and then slide hanging ball
off of the downrod. [Refer to diagram 1.]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will keep
the wires together when threading them through
the downrod. [Refer to diagram 2.]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack
from the upper end of the downrod.
[Refer to diagram 2.]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert
pin and clip that were previously removed. Tighten
yoke set screws and nuts securely. [Refer to diagram
2.]
Locate canopy cover and anti-sway adapter in
hardware pack. Slide yoke cover, canopy cover,
anti-sway adapter and canopy over downrod. [Refer
to diagram 3.] (Note: Canopy cover must be turned
with shiny side toward motor housing. If using
anti-sway adapter, it must be turned with flat side
toward the canopy.)
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
Loading ...
Loading ...
Loading ...