IIlnstallation I Gas Slide-In Rangel
nstructions JGS905, JGS968, PGS968
Ir_ Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.comIn Canada, call 1.800.361.3400 or Visit our Website at: www.geappliances.ca I
IN THE COMMONWEALTH OF
MASSACHUSETTS:
• This product must be installed by a
licensed plumber or gas fitter.
• When using ball-type gas shut-off valves,
they shall be the T-handle type.
• A flexible gas connector, when used, must
not exceed 3 feet.
PARTS INCLUDED
Screws
Rear Filler
2 Screws
Anti-Tip Bracket
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
• IMPORTANT - Savethese
instructions for local inspector's use.
• IMPORTANT - Observeall
governing codes and ordinances.
• Note to Installer - Be sure to leave these
instructions with the Consumer.
• Note to Consumer - Keep these
instructions for future reference.
• Product failure due to improper installation
is not covered under the Warranty.
-&WARNING - This appliance must
be properly grounded.
• IMPORTANT - Leak testing of the
appliance shall be conducted according to
the manufacturer's instructions.
• Proper installation is the responsibility
of the installer and product failure due to
improper installation is NOT covered under
warranty.
MATERIALS YOU MAY NEED
Joint Sealant Pipe Fittings Shut Off Valve
CSA-Approved Flexible Gas Line
3/8" Min. ID, 1/2" NPT Connection,
3-foot Maximum Length (Massachusetts Only)
TOOLS YOU WILL NEED
1/4" Nut Driver
Phillips Head
Screwdriver
Tape Measure
Safety Glasses
Level
Pipe Wrench
Wrench or Pliers
(for 1-7/16" Nut)
Drill
31-10665 10-07 JR
1
Loading ...
Loading ...
Loading ...
