Loading ...
Loading ...
Loading ...
WINTEROR LONGTERMSTORAGE Protectingthe Pump
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action.
Initial Storage Procedures
1. Flushdetergent bottle (if used) by removing it from the
foam lance and pouring out all remaining solution.
2. Rinsedetergent bottle out with fresh clean water and
reinstall onto foam lance.
3. Run the electric pressurewasher with wand set to high
pressure spray. Flush for one or two minutes.
4. Pressthe master ON/OFFswitch to the OFF(0) position.
Remove power cord plug from electrical outlet.
5. Turn off water supply. Point gun in a safe direction, press
trigger lock button and squeezetrigger to relieve trapped
pressure. After a few moments, releasetrigger on spray
gun.
6. Disconnect garden hose from the water supply and the
electric pressure washer. Disconnect pressure hose from
the pump and the spray gun.
7. Drain water from hosesand spray gun, then use a cloth
or equivalent to wipe off all exterior surfaces.
8. Ensurethat inlet and outlet hoses are disconnected from
the pump. Then drain water from pump by tipping unit on
its front side (water inlet facing down).
NOTICE Water left in the pump could freezeand damage the
pump.
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver, Model 74403, to treat
pump. This prevents freeze damageand lubricates plunger
and seals.
NOTICE PumpSaver is available as an optional accessory. It
is not included with the electric pressure washer. Visit
sears.com,your local Sears store or your nearestauthorized
service center to purchase Pump Saver.
NOTICEYou must protect your unit from freezing
temperatures.
• Failureto do so will permanently damageyour pump
and render your unit inoperable.
• Freezedamage is not covered under warranty.
To use PumpSaver, make sure the electric pressure washer
is turned off and inlet and outlet hosesare disconnected.
Readand follow all instructions and warnings given on the
PumpSavercontainer.
Final Storage Procedures
1. Coil power cord and store on accessory tray.
2. Wrap high pressure hose on hose reel.
3. Store spray gun and accessories on accessory tray.
4. Store unit in a clean, dry areathat is protected from
freezing temperatures.
5. Cover unit with a suitable protective cover that does not
retain moisture.
17
Loading ...
Loading ...
Loading ...