Loading ...
Loading ...
Loading ...
USER REPLACEABLE SERVICE PARTS
REPLACEMENT PART PART NUMBER
Spooi with 0.065 inch Trimmer Line 952711602
Line Guide Ring 530403949
Cap Assembly 530403810
Assist Handle 530403805
Bolt Carriage, 1/4-20 530403886
Wing Nut 530016152
Shield Assembty 530403914
Edge Guide 530403824
oWARNING: Perform the following
steps after each use.
• Stop the unit and disconnect the power
source when not in use.
• Carry the unit with motor stopped.
• Store the unit so the line limiter btade can-
not cause injury.
• Store unit and extension cord indoors in a
high, dry place out of the reach of children.
Store unit unplugged.
• Store unit with all guards in place. Position
unit so that any sharp object cannot acci-
dentally cause injury.
TROUBLESHOOTING TABLE
_lk WARNING: Always stop unit and disconnect from the power source before per-
forming all of the recommended remedies below except remedies that require unit to
be operating.
TROUBLE CAUSE REMEDY
Trimmer head 1. Crowding trimmer line 1. Allow tip of line to do the cutting.
stops under a against material being
load or does not cut.
turn when switch 2. Electrical failure. 2. Contact your authorized service dealer.
is pressed. 3. Thrown circuit breaker. 3. Check breaker box.
4. Debris stopping head. 4. Remove debris.
Line does not 1. Line improperly routed 1. Check line routing.
advance or in head.
breaks while 2. Line improperly 2. Rewind line tightly and evenly.
cutting, wound into spool.
3. Incorrect line size 3. Use only 0.065 inch (1.65 mm) dia. line.
4. Not enough line 4. Remove cover and pull 4 inches
outside of head, (10 cm) of line out of head,
5, Dirt buildup on unit, 5, Clean unit.
Line welds onto 1, Line size is incorrect. 1. Use only 0,065 inch (1.65 ram) dia, line,
spool, 2, Incorrect spool, 2. Replace with correct spool,
3, Line is being crowded 3. Cut with tip of line fully extended.
against material being
cut.
Line releases 1. Line improperly 1. Check line routing.
continuously, routed in head.
2. Spool damaged. 2. Replace spool.
Line usage is 1. Line improperly routed 1. Check line routing.
excessive, in head.
2. Line size is incorrect. 2. Replace spool.
3. Crowding line against 3. Cut with tip of line fully extended.
material being cut.
4. Spool worn or damaged 4. Replace spool.
Line pulls back 1. Too little line outside 1. Remove cover and pull 4 inches
into head. of head. (10 cm) of line outside of head.
2. Line size incorrect. 2. Use only 0.065 inch (1.65 mm) dia. line.
8
Loading ...
Loading ...
Loading ...