Loading ...
Loading ...
Loading ...
Page 10
Wall Installation
This type of installation is similar to roof mounting, ensuring that the pipe extends at least 50mm past the wall
surface refer gure 2. If the pipe length is shortened, reproduce the power cord exit slot on the inside of the
wall.
NOTE: By decreasing the length of the SteelFlex
™
duct from which specied (refer to installation instructions)
there will be an increase in airow and noise levels as a result. This increase in airow can cause movement of
air to be heard through the system and inhibit the system to run silently.
Figure 2: Wall installation
Wall
Wall Optional
Fitment Pipe
Optional Mounting Flange
(P40113MF*)
Optional Backdraft Shutter
150mm PVC Stormwater Pipe
From outside face of ange to end of pipe (or
wall if mounting ange not used)
50
50
Locking screws to be fully
tightened engaging in holes
Locking holes at 4 and 10 o’clock
Locking screws
Power cord to
240V supply
Seal with silicone or
urethane
Fill gap between pipe
and wall or t second
wall mount ange if
required
900
motor
*Optional wall mounting ange (P40113MF) is available
from Schweigen, please contact 1300 881 693.
4. Installation
IMPORTANT
For more SteelFlex
™
ducting instructions, refer page 16.
Loading ...
Loading ...
Loading ...