Loading ...
Loading ...
Loading ...
Summit Appliance Division · Felix Storch, Inc. · www.summitappliance.com · 718-893-3900 · info@summitappliance.com
8) The pump has two tubes, a thinner tube which runs to the metal water cut-off valve and a thicker
water pull tube, which pulls water from your freshwater jug.
9) To connect the pump to the valve, place the valve nut over the water line.
10) The plastic sleeve has a wider and a narrower side. Place the plastic sleeve onto the water line
through the larger side.
11) Insert the metal flange into the end of the water line as far as it will go.
12) Wrap the threading of the valve, then secure the water line to the cut off valve. Tighten the nut as
much as you can.
13) Now that the water intake line is attached, wrap the other two threads of the cut-off valve in Teflon
tape, then connect the small ends of the two faucet connector lines to the cut off valve.
14) Wrap the threads of the faucet underneath the sink, then attach the wider ends of the connector lines
to the faucet.
15) Set the freshwater jug in the rear right-hand corner. Uncap the freshwater jug and insert the water pull
into the freshwater jug. Be careful, as some water may overflow when the device is first inserted.
16) Attach the drainage pipe to the underside of the sink drain, then set the end into the wastewater jug.
17) Open the water cut-off valve.
If you need further assistance, contact Summit Tech. Support, or visit
www.summitappliance.com/handwash-station to see a video of the installation.
Final Assembly