Loading ...
Loading ...
Loading ...
Before You Call
Solutions to Common Problems
Before you call for service, review this Hst, it may save you time and expense, The Hst incUudes common occurrences that
are not the resuUtof defective workmanship or materiaUs in this appliance,
OCCURRENCE POSSIBLE CAUSE/SOLUTmON
Control pads for Sensor Cooking, The oven door was opened and closed without initiating a cooking cycle
One-Touch Cooking, and Defrost within three minutes. Touch STOP/CLEAR to resume normal pad operation.
will not operate.
Microwave oven Hght does not ff one of those situation appear phase check the eUectrbaUoutbt, fuse and/or
come on. CooJing fan does not circuit breaker, if they are functioning properly, contact Sears Part & Repair, A
work. Turntable does not rotate, microwave oven shouUd never be servicer by a "doqt-yourseW' repair person,
Water in a cup in microwave does If this situation appears please check the electrical outlet, fuse and/or circuit
not warm. breaker, If they are functioning properly, contact Sears Part & Repair, A
microwave oven should never be servicer by a "doqt-yourseW' repair person,
Time appearing in the dispJay is Please check Demonstration Mode on page 16 and cancel,
counting down very rapidty.
Wall Oven ControJ Seeps and
DispJays any F code error (example
Fll).
-dr- is displayed.
Electronic control has detected a fault condition, Press STOP/CLEAR to clear
the display and stop the beeping, Reprogram the oven, If a fault reoccurs,
record the fault number, Press STOP/CLEAR and call Sears or another
ii
qualified servicer,
The door was left open and controls set for self-cleaning cycle, Close the door
and push CANCEL pad,
Installation. Place oven rack in center of oven, Place a level on the oven rack, Contact
installing agent if rack and cabinet cutout flooring are not level,
Kitchen cabinet misalignment may make oven appear to be not level, Be sure
cabinets are square and level, Contact cabinet maker to correct problem,
Entire Wall oven does not operate. When the oven is first plugged in, or when the power supply to the oven has
been interrupted, the display wiii flash, The oven cannot be programmed until
the clock is set,
Be sure electrical cord is securely connected into the electrical junction box,
Cord/plug is not installed and/or connected, Cord is not supplied with oven,
Contact Sears or another qualified servicer,
Service wiring not complete, Contact Sears or another qualified servicer,
Power outage, Check house lights to be sure, Call your local electric company,
Short in cord/plug, Replace cord/plug,
Controls are not set properly, See instructions under Setting Oven Controls
to set the controls,
House fuse has blown or circuit breaker has tripped immediately following
installation, House fuse may not be fully engaged, Check fuse and screw or
engage circuit breaker securely,
House fuse has blown or circuit breaker has tripped after the oven has been
installed and previously operating, Call Sears or another qualified servicer,
33
Loading ...
Loading ...
Loading ...