Loading ...
5. Once LED light turns off Enter 4-digit pin
6. Unit will Chirp twice and start EXIT delay countdown. LED light will flash for duration of delay.
7. Once the LED light stops flashing the unit is ARMED
8. When unit is triggered – LED light will flash for duration of ENTRY Delay – if unit is not disarmed using the 4-digit
code the alarm will sound until DISARMED.
9. After unit is DISARMED the unit will beep twice for confirmation.
OPERATING IN HOME MODE
1. To activate HOME mode, enter first 3-digits of your 4-digit pin
2. LED light will flash, unit will chirp twice with solid LED light for confirmation
3. Unit will begin 15 second EXIT delay with LED light flashing.
4. Once unit has stopped flashing HOME mode is activated.
5. When unit is triggered the ALARM will sound IMMEDIATELY.
6. Enter 4-digit pin to DISARM the unit.
TESTING
It is recommended that the alarm is tested immediately after installation and at regular intervals not exceeding 1 month.
Note: A cloth can be used to cover the siren and reduce the sound output of the alarm during testing.
BATTERIES
Do not allow the batteries to carrode and leak as this may cause permanent damage to the product. Take care to insert
the batteries with the correct polarity as shown inside the battery compartment. Do not mix new and old batteries or
different types of batteries. Do not use rechargeable batteries.
At the end of their useful life, the batteries should be disposed of via a suitable recycling center. Do not dispose of with
your normal household waste. DO NOT BURN.
FCC Regulation: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING
Limitations of Alarm Products
Test product regularly to ensure it functions in accordance with these instructions. Security Equipment Corporation (SEC)
is not providing insurance or any guarantee that the risk of burglary or robbery will be reduced or prevented even if this
product is used properly. SEC recommends that users obtain proper insurance coverage for these risks. SEC does not
represent or warrant that this product may not be compromised or circumvented, that it will provide proper or
adequate warning, or that the use of this product will prevent injury, property damage or other losses. Note that this
Loading ...