Loading ...
Loading ...
Loading ...
This Owner's Guide provides specific operating instructions
for your model. Use the freezer only as instructed in this
Owner's Guide. Before starting the freezer, follow these
important first steps.
INSTALLATION
• Choose a place that isnear a grounded electrical outlet.
Do Not use an extension cord or an adapter plug.
• Forthe most efficient operation, the freezer should be
located where surrounding temperatures will not exceed
110°F(43°C). Temperatures of 32°F (0°C) and below will
NOT affect freezer operation. Additional compressor
heaters are not recommended.
• AIIowepacearoundtheunitforgoodaircirculation.
Leave a 3 inch (75 ram) space on all sides ofthe freezer
for adequate circulation.
InstallaUoa
3" (7errs)
(75 ram)
NOTE: The exterior wallsofthefreezer may become quite
warm as the compressorworkstotransferheatfrom the
inside.Temperaturesas muchas 30° Fwarmerthanroom
temperature canbe expected. Forthis reasonitisparticu-
larlyimportantin hotterclimatestoallowenoughspacefor
air circulationaroundyourfreezer.
LEVELING
The freezer musthave all bottom corners resting firmly on
a solid floor. The floor must be strong enough to support a
fully loaded freezer. NOTE: It is Very Important for your
freezer to be level in order tofunction properly. Ifthe
freezer isnot leveled during installation, the door may be
misaligned and notclose or seal properly, causing cooling,
frost, or moisture problems.
To Level Upright Models:
After discarding cratingscrews and woodbase, usea
carpenter'slevelto levelthefreezerfromfront-to-back.
Adjust the plasticleveling feet infront,½ bubblehigher,so
thatthedoorcloses easily when lefthalfwayopen.
"_-. ) Cra_ir_ Soews
Unpactdng and Leveling - Upnght Models
To Level Chest Models:
Ifneeded, add metal orwood shimsbetweenfootpadsand
floor.
CLEANING
• Wash any removable parts, the freezer interior, and
exterior with mild detergent and warm water.Wipe dry.
Do not use harsh cleaners on these surfaces.
Do notuse razor blades or othersharpinstruments,
which can scratch the appliance surface when removing
adhesive labels.Any glue left from the tape can be
!
removed with a mixture of warm water and mild deter-
gent, or touch the residue with the sticky side of tape
alreadyremoved.Donotremove theserialplate.
I_=1_ To allow door to
close and seal properly, DO NOT let
food packages extend past the front
of shel,,_s.
Shelf Front
5
Loading ...
Loading ...
Loading ...