Loading ...
Loading ...
Loading ...
ITEM TABLEOFLOOSE PARTS QTY.
A
B
C
D
Basic saw assembly 1
Owners Manual .................... 1
Saw Table assembly ................ 1
Bag Assembly Part #69189
Containing the following parts:
Switch, Key ........................ 1
Nut, Wing 1/4-20 .................... 1
Screw, Truss Hd. 1/4-20 x 3t4 ........ 1
Washer 17!64 x 5!8 x 1/16 ........... 1
Washer 17164 x 47164 x 1/16 ......... 2
Indicator, Bevel .................... 1
Screw, Pan Cross 10-24 x 1/4 ........ 1
Insert, Table ....................... 1
Knob .............................. 2
C
assembly
MOUNTING BAND SAW TO WORKBENCH
If band saw is to be used in a permanent loca-
tion, it should be fastened securely to a firm sup-
porting surface such as a workbench.
If mounting to a workbench, holes should be
drilled through supporting surface of the work-
bench using dimensions illustrated.
1. Each leg should be bolted securely using
5/16" diameter machine screws, Iockwashers,
and 5/16" hex nuts (not included). Screw
length should be !1/2" plus the thickness of
the bench top.
2. Locate and mark the holes where band saw is
to be mounted.
3. Drill (4) 3/8" diameter holes through work-
bench.
4. Place band saw on workbench aligning holes
in feet with holes drilled in workbench.
5. Insert all four 5/16" screws and tighten.
NOTE: Front two mounting bolts should be
inserted from the bottom with washer and nut on
top.
_ 3,' 8" [)IAMETE''_ -'_
6-5/16" (4_ HOLES
__--_ 10-13/16"-._
An alternate method of mounting is to fasten
band saw to a mounting board. The board should
be of sufficient size to avoid tipping of saw while
in use. Any good grade of plywood or chipboard
with a 314" minimum thickness is recommended.
(Thinner chipboard can break.)
o Follow instructions for mounting to work-
bench, substituting a board 18" x 24" mini-
mum size and using 5/16 inch flat head
screws, Iockwashers, and hex nuts (not in-
cluded). Screw length should be 11/2'' plus
the thickness of the mounting board.
NOTE: For proper stability, holes must be
counter sunk so screw heads are flush with the
bottom surface of supporting board.
18" MIN
4
24" MtN
/*
--_+ 3/8" D_AMETER _4, HOL_S
6-5/16"
_---- 10 13,16"-_-_
"I
Loading ...
Loading ...
Loading ...