KSTAT10-2HC User Manual

Loading ...

INSTALLATION INSTRUCTIONS

Direct Unit Mounting:

The previous directions are the preferable way to mount the new rear grill. The units performance is

slightly better and the possibility of draughts is reduced. As a last resort, direc t mounting of the grille

to the unit can be considered.

Note: The grille must be installed prior to inserting the unit into the sleeve.

1. Attach the 2 seal pieces (1 X3/8 X14 ) as shown in Fig. 1.

2.Position the grille over the rear of the unit making sure that:

a. The double s et of screw holes are at the bottom.

b. The fins of the grill are pointed away fr om the unit.

3. Align the top of the grille with the top of the unit. The overhang on each side is equal.

4. If the unit has not been pre-drilled (some models), carefully drill 4-1/8 holes through the

grille and into the side flange of the unit approximately 1 to 2 from the top and bottom as

in Fig. 2, 3 .

(Be careful not to drill into the copper heat exchanger coils.)

5. Install 4 - #8 self tapping s crews to affix the grille to the unit.

6. Insert the unit into the sleeve.

Loading ...

Keystone KSTAT10-2HC 10,000 BTU 230V Through-The-Wall Air Conditioner | 10,600 BTU Supplemental Heating | LCD Remote Control | Sleep Mode | 24H Timer | AC for Rooms up to 450 Sq. Ft. |