Loading ...
Loading ...
Loading ...
OPERATING YOUR WINE COOLER
1. Turning on your wine cooler. Plug in and switch on the wine cooler by pressing on the power button for a
few seconds. When you use the wine cooler for the first time (or restart the wine cooler after having it
power off for a long time), there will be a few degrees variance between the temperature you have
selected and the one indicated on the LED readout. This is normal and it is due to the length of the
activation time. Once the wine cooler is running for a few hours everything will stabilize.
Important
If the unit is unplugged, power is lost or turned off, wait 3 or 5 minutes before restarting the unit. The wine
cooler might not start if you attempt to restart before this time delay.
2. Operating noises. To reach the desired temperature settings, Euro wine coolers, like all wine coolers
operating with compressors and fans, may produce the following types of noises. These noises are normal
and occur as follows:
Gurgling sound, caused by the refrigerant flowing through the appliance’s coils;
Cracking/popping sounds, resulting from the contraction and expansion of the refrigerant gas to
produce cold;
Fan operating sound, to circulate the air within the wine cooler.
3. Loading your wine cooler. You might load your wine bottles in single or double rows while taking note of
the followings: If you do not have enough bottles to fill your wine cooler, it is better to distribute the load
throughout the wine cooler as 6 bottle arrangement so as to avoid” all on top” or “all below” type loads.
Important
Do remove or relocate wooden shelves in the model E150WSCS to accommodate large type of bottles
or increase the capacity of the cabinet by stacking the bottles up when necessary.
Keep small gaps between the wall and the bottles to allow air circulation.
Do not over load your wine cooler to facilitate air circulation.
Do not stack more than 1.5 rows of standard 750ML bottles per shelves to facilitate air circulation
Loading ...
Loading ...
Loading ...