Loading ...
Loading ...
Loading ...
En-5
PREPARATION
CAUTION!
●
Take care to prevent infants from acciden-
tally swallowing batteries.
●
When not using the Remote Controller for
an extended period, remove the batteries to
avoid possible leakage and damage to the
unit.
●
If leaking battery fl uid comes in contact
with your skin, eyes, or mouth, immediately
wash with copious amounts of water, and
consult your physician.
●
Dead batteries should be removed imme-
diately and disposed of properly, either in a
battery collection receptacle or to the appro-
priate authority.
●
Do not attem pt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about 1 year under
normal use. If the Remote Controller’s
operating range becomes appreciably
reduced, replace the batteries and press
the RESET button with the tip of a ball-
point pen or other small object.
Load Batteries (AAA/R03/LR03
2)
1
Press and slide the battery compartment lid on the
reverse side to open it.
Slide in the direction of the arrow while pressing the mark.
2
Insert batteries.
Be sure to align the battery polarities ( ) correctly.
3
Close the battery compartment lid.
Set the Current time
1
Press the CLOCK ADJUST button (Fig. 5
S
).
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET ( / ) buttons (Fig. 5
R
) to
adjust the clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in 1
minute increments; hold the buttons depressed to change the time quickly in
10 minute increments.)
3
Press the CLOCK ADJUST button (Fig. 5
S
) again.
This completes the time setting and starts the clock.
To Use the Remote Controller
●
The Remote Controller must be pointed at signal receiver (Fig.3
4
) to operate correctly.
●
Operating Range: About 7 m.
●
When a signal is properly received by the air conditioner, a beeping sound will be
heard.
●
If no beep is heard, press the Remote Controller button again.
Remote Controller Holder
3
To remove the Remote Con-
troller (when use at hand).
1
Mount the Holder.
2
Set the Remote Controller.
Screws
Insert
Press in
Slide up
Pull out
Turn on the Power
1
Turn on the circuit breaker
9315345387_OM_EN.indb 59315345387_OM_EN.indb 5 12/2/2010 8:44:35 AM12/2/2010 8:44:35 AM
Loading ...
Loading ...
Loading ...