Loading ...
Loading ...
Loading ...
CYLINDER
O
O
Remove spark plug.
Pour one ounce (29 ml) of oil through spark
plug hole intocylinder.
• Pull starter handle slowly a few times to
distribute oil.
• Replace with new spark plug.
OTHER
• Do not store gasoline from one season to
another.
o Replace your gasoline can if your can starts
to rust. Rust and/or dirt in your gasoline will
cause problems.
= If possible, store your unit indoorsand cover
itto give protection from dust and dirt.
° Cover your unit with a suitable protective
cover that does not retain moisture. Do not
use plastic. Plastic cannot breathe which
allows condensation to form and will cause
your unit to rust.
iMPORTANT: Never cover mower while
engine and exhaust areas are still warrn.
CAUTION: Never store the tawn mower with
gasoline in the tank inside a building where
fumes may reach an open flame or spark.
Allow the engine to cool before storing in any
enclosure.
TROUBLE SHOOTING
PROBLEM CORRECTION
Wilt not start
Loss of power
• Dirty air filter.
, Out of fuel.
• Stale fuel.
Water in fuel.
° Spark plug wire is
disconnected.
° Bad spark plug.
- Loose blade or broken
blade adapter.
= Control bar in released
position
• Control bar defective
,,j
o Rear of lawn mower
housing/blade dragging
in heavy grass,
= Cutting too much grass°
° Dirty air filter.
= Buildup of grass, leaves
and trash under mower_
• Too much oil in engine.
• Walking speed too fast.
Worn, bent or loose blade.
o Wheel heights uneven.
° Low engine speed.
Buildup of grass, leaves,
and trash under mower.
Poorcut-uneven
° Clean/replace air filter.
° Fill fuel tank.
= Drain tank and refill with fresh
clean fuel.
° Drain fuel tank and carburetor
and refill tank with fresh
gasoline.
° Connect wire to plug,.
- Replace sparkplug.
• Tighten blade bolt or replace
blade adapter.
° Depress control bar to handle.
° Replace control bar.
ii J,,J,,* i ,,
• Set in "Higher Cut" position.
• Set in "Higher Cut" position.
o Clean/replace air filter.
= Clean underside of mower
housing.
° Check oil level
° Cut at slower walking speed.
° Replace blade. Tighten blade
bolt,
• Set all wheels at same height.
= Set engine speed control in
fast position.
• Clean underside of mower
housing_
16
Loading ...
Loading ...
Loading ...