Loading ...
Loading ...
Loading ...
17469 18 REV. 10-088
SERVICE AND ADJUSTMENTS
Adjusting The Cutting Height:
~Push out on the Deck Lift Handle and raise or lower the deck to the desired position.
~Position 1 is the lowest setting and Position 8 is the highest position
~The cutting range is from approximately 1 1/2” to approximately 4 1/2”
~Further fine tune the deck cutting height by raising or lowering the deck relative to the lift arm. This can be done by moving
the hole location of 17408TK on both the right and left sides. Simply set the deck lift handle to the desired position, remove
the bolts holding the right and left 17408TK's in place, and re assemble to another hole location in the 17408TK. Make sure
both 17408TK's on your mower are assembled with the same hole location for a level cut. This adjustment will allow you to
vary the lowest or higest deck settings.
Deck Leveling
:
(TOOLS REQUIRED)
~ 2 - ½” Wrenches or ½” Socket with drive ratchet
~ Bubble Level
~Lower the cutting deck down to the lowest position (position 1)
~Loosen the nuts and bolts on the crescent slotted, rear adjustment plates (2 plcs).
~Place the level on a smooth part of the deck shell and with the front rollers on the ground raise or lower the rear of the deck.
~Re-tighten the nuts and bolts on the crescent adjustment places one the desired adjustment is made.
~Lift deck using the deck lift handle to the desired position
Parking Brake:
~The Swisher ZT2452A is equipped with separate parking brake system.
~The parking brake is actuated with the lever in the front control panel of the mower frame. Up is engaged and down in
disengaged.
~Adjustment for the system is located on the end of the brake linkage near the hydrostats under the rear of the mower.
~Raise both the rear wheels off the ground
~Disengage both hydro's with the hydro release handles at the rear of the unit. Pull the levers to disengage.
~Adjust the parking brake so that the wheels turn freely in the disengage position.
~The wheel should not turn when the handle is moved to the engaged or upward position.
~Lower unit back to the ground
~Re-engage the hydro's at the rear of the unit by pushing the levers inward
.
~
It is only a parking brake and not an emergency brake!
~The parking brakes design is such that it has replaceable wear items which should be checked at regular intervals to
observe wear.
~The wear items include the (1) cog wheel and the (2) tooth arm. These items are not included as warranty items! These
are considered normal wear items and must be maintained.
~The parking brake must be kept in proper adjustment at all times to insure proper o
peration.
Loading ...
Loading ...
Loading ...