Loading ...
Loading ...
Loading ...
Page:
7
User Manual:
Installing your Cooktop
It’s important to carefully read the following installation instructions before beginning the installation of your cooktop.
IMPORTANT! The connection of this cooktop must be carried out by a suitably qualied and licensed
person, in accordance with the current version of the following:
→ AS/NZS 3000: 2007 Wiring Regulations
→ 2010 Electricity Safety Regulations
→ The installation instructions within this user manual
POSITIONING
The adjacent cabinetry and wall materials must be able to withstand a minimum temperature rise of 100°C above the
ambient temperature of the room.
→ This cooktop has been designed for use within a kitchen. The cooktop must not be
installed in a bathroom or shower room.
This appliance is classied as Class 3 and therefore is to be built into a kitchen unit (depending on size) or 600mm deep
worktop, providing the following minimum distances are allowed:
→ The edges of the hob must be a minimum distance of 55mm from a side or rear wall.
→ 700mm between the highest point of the hob surface (including the burners) and the
underside of any horizontal surface directly above it.
→ 400mm between the hob surface, providing that the underside of the horizontal surface
is in line with the outer edge of the hob. If the underside of the horizontal surface is lower
than 400 mm, then it must be at least 50 mm away from the outer edges of the hob.
→ 50mm clearance around the appliance and between the hob surface and any
combustible materials.
INSTALLING THE COOKTOP
→ Cut a hole in the bench top that corresponds with the relevant drawing shown below.
Loading ...
Loading ...
Loading ...