Loading ...
Loading ...
ASSEMBLY INSTRUCTIONS
3
Outlet Box Screw
Outlet Box
STEP 2:
a. Remove lock ball and Hex Nut from crossbar
assembly (AA).
b. Fit ceiling canopy (A) over the nipple on crossbar
assembly and secure with lock ball.
Note: The ceiling canopy should be snug against
the ceiling and the lock ball.
Ÿ If not, adjust the length of the nipple on the crossbar
assembly by unscrewing the preassembled hex
nut.
Ÿ Then, screw the nipple in or out of the crossbar
until the desired length is achieved.
Ÿ Once the ceiling canopy is secure, remove the lock
ball and ceiling canopy and proceed to Step 3.
lock ball
Hex Nut
Hex Nut and
Lock Washer
STEP 1:
a. Secure the crossbar (AA) to the outlet box (not
included) with outlet box screws. Tighten until
snug.
Note: The preassembled mounting nipple on the
crossbar should protrude outward.
AA
A
AA
STEP 3:
a. The lanyard is provided as a means to support the
fixture from the junction box while connecting the
electrical wires. This enables the fixture to hang
from the junction box and your hands are free to
make the wire connections.
b. Turn the button stop so it may be inserted into the
crossbar slot. Make sure the button stop is
completely inside the crossbar.
c. Slowly release the fixture to make sure it is
supported by the button stop.
d. Proceed to Step 4. Once wiring is complete, the
lanyard will push into the junction box when the
Ceiling Canopy is Attached to the ceiling.
Crossbar Assembly
Button Stop
Lanyard
Slot
WHITE
BLACK (OR RED) WIRE
WHITE
BLACK
FROM SUPPLY
FROM SUPPLY
FROM FIXTURE
FROM FIXTURE
STEP 4:
* Use Wire Connectors (supplied) to connect the
wires.
a) Ground Wire:
1. Wrap supply ground wire around green ground
screw on mounting bracket, no less than 2 inches
from the end of the wire. Tighten ground screw.
2. Connect fixture ground wire to supply ground
wire with wire connector.
b) Supply Wire:
1. Connect the supply white wire to the white
fixture supply wire with wire connector.
2. Connect the supply black (or red) wire to the
black fixture supply wire with wire connector.
3. Wrap each connection with approved electrical
tape and carefully stuff all of the connected wires
into the outlet box.
GROUND WIRE
GROUND WIRE
FROM SUPPLY
FROM FIXTURE
GREEN GROUND SCREW
Loading ...