Loading ...
Loading ...
Loading ...
SANTOS: User and maintenance manual
98165 EN 1.1 - 03 2018 5 / 19 www.santos.fr
14. Never connect several appliances to the same power socket.
15. Never use the appliance outdoors.
16. Never place the appliance close to or on a source of heat.
17. This appliance is a professional machine designed exclusively for
professional use. It is not designed for household use.
18. This appliance is not designed for use by people (including children) whose
physical, sensorial or mental capacities are impaired or by people with no
experience or knowledge, unless they have been supervised or given
training in the use of the appliance beforehand by a person responsible for
their safety.
Supervise children to ensure they do not play with the appliance.
ELECTRICAL CONNECTION:
The appliance is available with a choice of two voltages for the power supply:
• 220-240V 50/60 Hz single phase
• 110-120V 50/60 Hz single phase
Line protection: the machine should be connected to a standard 2-pole + earth electric
socket. The installation should be fitted with an RCD and a fuse rated
at 16A. The appliance must be earthed
CAREFUL:
• Before connecting the machine, check that the mains electrical voltage is the same
as the voltage for your appliance. Its value is shown:
either on the identification plate under or behind the machine
or on the identification plate on the last page of this manual.
• If the power supply cable (22) is damaged, it should be replaced by a SANTOS
approved dealer, SANTOS or a person with similar qualifications to avoid any
danger.
• The plug must remain easily accessible while the appliance is in use.
USING FOR THE 1st TIME:
1. Lift up the cover (2) after turning the unlocking lever (6) by one quarter of a turn
Fig. 2
2. Lock the cover (2) in the top position.
3. Turn and remove the bowl (1). Fig. 3
4. Remove the top screw (11).
5. Remove the bottom screw (12).
6. Remove the sieve (13) with the 2 scrapers (15).
7. Unscrew the discharge cone (17) by pressing down and remove the seal (18) and
the ring (19) Fig.4
8. Wash all the components in contact with the food in clean water: the plunger (4),
the feed channel (3), the bowl (1), the top screw (11), the bottom screw (12), the
!
Loading ...
Loading ...
Loading ...