Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENTS
_ ARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST-
MENTS:
• Depress brake pedal fully and set parking brake.
Place attachment clutch in "DISENGAGED" position.
• Turn ignition key to "STOP" and remove key.
• Make sure the blades and all moving parts have completely stopped.
• Disconnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.
TRACTOR (See Fig. 24)
TO REMOVE MOWER
Place attachment clutch in "DISENGAGED" position.
Lower attachment lift lever to its lowest position.
Disengage belt tension rod (K) from lock bracket (L).
I& CAUTION: Belt tension rod is spring
loaded. Have a tight grip on rod and re-
I
lease slowly.
Remove mower belt from electric clutch pulley (M).
Disconnect front link (E) from mower - remove retainer
spring and washer.
Go to either side of mower and disconnect mower
suspension arm (A) from chassis and rear lift link (C)
from rear mower bracket (D) - remove retainer springs
and washers.
Go to other side of mower and disconnect the suspen-
sion arm and rear lift link.
Turn tractor steering wheel to the left as far as it will
go.
Slide mower out from under right side of tractor.
TO INSTALL MOWER
Follow procedure described in "INSTALL MOWER AND
DRIVE BELT" in the Assembly section of this manual.
TO LEVEL MOWER
Make sure tires are properly inflated to the PSI shown on
tires. If tires are over or under inflated, it may affect the
appearance of your lawn and lead you to think the mower
is not adjusted properly.
VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 28)
With all tires properly inflated and if your lawn appears
unevenly cut, determine which side of mower is cutting
lower.
NOTE: As desired, you can raise the low side of mower or
lower the high side,
CAUTION: After rear lift links are discon-
nected the attachment lift lever will be
I
spring loaded. Have a tight grip on lift lever
when changing position of the lever.
FIG. 25
21
Loading ...
Loading ...
Loading ...