Loading ...
Loading ...
Loading ...
CHUCK (F_G.E,F) SPINDLE SPF_EDS (FIG.H)
i. #1_peetand dean the holeinthechuck {I)and the ThisddH offers5 spindlespeeds from620 b 3100 R.RM,
spindb (2)° The h ghentspeed isobtainedwhen _e be_ isposition_
2, Remove al_grease, coatings_ and pa[_ c_esfrom the en the largest motor pulley step and the smallest spindle
chuck and spindle serrates w_th a clean cbth
3 Open the c:huck iaws (3}_ by bsrning me chuck: barre!
c!ockwise_ end make sure the iaws are comp[ete_ly
recessed _naide lhe chuck,
4_ Seat the chuck (1) (Fig. F) of_toth_ spindle by p_aciag
a b_ock d wood under '_hechucE and tapping t_
wood w_h a hamme_ or tap _he chuok with a rubber
mallet or p_asfieotpped hemmer.
& Do ne_:pap the chud_, wi_h e me_eJhamme_
Fig.E
Disconnect the dr_I press from 1hepower soume belore
mak}n# any adjustments,
Fig. H
Moto_-
3100
F g° F
3
2340
1720 :_
1100 c_
620
TO ADJUST AND TENSION THE BELT (FIG. |)
1. Open the beff housing cover (1).
2, Turn the belt tension knob (2_ _o_o_e_ the motor
Pension spring,
3. Pu_ lhe motor (3) froward the _rent.of the dr#_press,
4. Ho_d the _otor _nthis posit_on, and set _e belt [6)
on 1he desired steps of the mobr (4} and spindle _5)
_OUNT|NG THE DR|LL PRESS (FIG. G)
Your ddHpress must _ s,scurely tasten_ by 1hetwo base 5
holes to a sten_ or workbench with h÷avy-dub/fasteners.
This wiiil prevent the ddH press from flppng over eliding
o_walking dudng opera,ion &
iMPORTANT: # the s_andor workbench ;hasa tenderly to
move duriRg operation, fasten _ securely to 15e#oor:
Fig, G
1, Dfiii press base
2, Bolt
& F_atwasher
4 Rubber washer
5. Worksuda_
6, F_a_waehett
7, Lockwasher
8 Hex nut
& Jam nat
1
5
Z
NOTE: Refer to the chart (7) located under the pu#ey
cover for se_-up pulley speeds.
Pivot the motor (3) away Promthe dr#t press head to
increase the belt tension and _ighten the tension
The belt (Cj should be _ght enough b preset sit.age,
Coffee1 tension is set _f_he belt flexes aoouf[ 1/2,"
when thunlb pressure _sapplied e_the midpoint o_
_hebe_ between the pulleys.
Fig, i
@
3
2
10
Loading ...
Loading ...
Loading ...