Loading ...
Loading ...
Loading ...
1
1
.
.
ATTACH THE FAN BLADES
Pg. #4
- Attach the blades to the fan motor assembly using the screws and flat
washers.
Fig.2a
- Install the light kit to the fan motor assembly by tightening three screws
- Connect polarized connectors of light kit to corresponding connectors
found in switch housing.
Metal Washer
Blade
Bracket Screw
Blade
Blade
Bracket
Lock Washer
Fig.2b
Red or Blue
Wires
WhiteWires
Black or
Blue Wires
Light Kit
Glass
Plastic Screw
Screw
Light Kit
Fig.2c
- Remove the 4 plastic screw from light kit.
- Install the glass an the light kit by tightening the 4 plastic screw.
Pg. #9
ELECTRICAL HOOK-UP
4
4
.
.
- Push all connected wires up into ceiling box.
Position the receiver into the canopy as shown direction.
C
Fig.7b
ANTENNA
(Leave unconnected
and do not cut)
VIEW AFTER INSTALLATION
5.
MOUNTING FAN ASSEMBLY
- Place two screws and washers on mounting plate (marked B on diagram)
which correspond with slots in canopy. Screw in two turns.
- Position canopy to mounting plate aligning slots to screws (marked B on
diagram) then turn to lock.
- Position and tighten the two screws and washers (marked A on diagram)
then tighten the two screws (marked B on diagram).
6.
6.
ENGAGE HEMISPHERE (Downrod Mount Only)
- Carefully rotate fan assembly until groove in hemisphere locks over tab of
canopy assembly.
WARNING: Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
NOTE:
When installing fan on sloped ceiling, make sure tab on hanger bracket
faces towards the top of the slope. Depending on the slope, a longer
downrod
may
be
required
to
prevent
fan
blades
from
hitting
the
ceiling.
Downrod
Hemisphere
Groove
Fig.8a Fig.8b
(A)
(B)
(B)
Washers
(A)
Mounting
Plate
Reciever
Fig.7a
BLACK
BLUE
WHITE
Canopy
ANTENNA
WHITE
120V
SUPPLY
CIRCUIT
Fan
BLACK
BLACK
WHITE
BLUE
Loading ...
Loading ...
Loading ...